HomeTrouble CodesU0189

U0189 — Lost Communication Digital Disc Playerchanger Module C

Generic OBD-II · all makesNetwork / communication

U0189 is a network communication diagnostic trouble code indicating that the vehicle's control modules can no longer communicate with Digital Disc Player/Changer Module 'C' on the data bus. This typically points to an infotainment or rear-seat entertainment component rather than an engine or emissions problem. The code is set when the expected messages from that specific disc changer module are missing.

Symptoms

What causes it — most likely first

1. Faulty Digital Disc Player/Changer Module C

The most common cause is an internal failure within the disc changer/player module itself, causing it to stop communicating on the network while other modules continue to function.

2. Wiring or connector fault to the module

Open, shorted, pinched, or corroded power, ground, or data-bus circuits between the module and the rest of the vehicle can interrupt communication.

3. Data bus network issue

A fault on the CAN, LIN, or other serial data bus segment serving this module—such as incorrect termination, bus shorting, or interference—can isolate the module.

4. Power or ground supply problem

A blown fuse, faulty relay, corroded ground point, or poor ignition feed can prevent the module from powering up and communicating.

5. Master infotainment/communication module fault

The head unit or gateway module that manages communication with the disc changer may be defective, though this is less common than a module or wiring fault.

6. PCM/ECM failure

A failed engine or powertrain control module is an extremely unlikely cause of U0189; it should only be considered after wiring, power, ground, bus integrity, and the disc changer module have been ruled out.

How it's diagnosed

  1. Confirm U0189 and record any related U-codes; multiple communication faults suggest a broader bus or power issue, while an isolated U0189 points to the disc changer or its circuits.
  2. Inspect the connectors and wiring harness at Digital Disc Player/Changer Module C for corrosion, bent pins, moisture intrusion, chafing, or poor pin fit.
  3. Check the module's battery power, ignition-switched power, and ground circuits with a digital multimeter; verify fuses and relays are intact and delivering proper voltage.
  4. Test the data bus signals at the module connector for correct voltage levels, resistance, and message activity according to the manufacturer's specification.
  5. If power, ground, and bus integrity are normal, remove or bypass the disc changer module to confirm communication resumes, indicating the module requires replacement.
  6. Only investigate the PCM/ECM or gateway module as a last resort after all wiring, power, ground, bus, and disc changer module possibilities have been eliminated.

Code facts & related codes

SystemNetwork / communication
StandardizationSAE generic — identical on every make

Frequently asked

Is U0189 an engine or emissions problem?

No. U0189 is a communication code for an infotainment or digital disc player/changer module. It does not indicate an engine, transmission, or emissions fault.

Do I need to replace the PCM for U0189?

Almost never. The PCM/ECM is rarely the cause of an isolated infotainment communication code. Diagnose the disc changer module, its wiring, power, ground, and data bus first.

Can I keep driving with U0189 stored?

Yes. This code normally does not affect engine operation, braking, or safety. It may simply mean the CD/DVD changer or related entertainment feature is unavailable.

What does the 'C' in U0189 mean?

The letter suffix identifies a specific instance of the module on the vehicle network. Multiple disc changer modules may be designated A, B, C, etc., depending on the vehicle configuration.