Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2022 Grand Caravan.
Engine, drivetrain, dimensions and economy.
| Overall length | 203.9 in |
| Overall width | 79.5 in |
| Overall height | 70.1 in |
| Wheelbase | 121.7 in |
| Curb weight | 4330 lb |
| Track (front / rear) | 68.5 / 68.5 in |
| Weight distribution (front / rear) | 55/45 |
Capacities, torques and tune-up values from the factory service manual.
| Camshaft Bearing/Carrier Cap Bolts or Studs | 7.4 ft-lbs |
| Engine Flywheel Bolts | 70.0 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 9.0 ft-lbs |
| Ignition Coil Primary Resistance | 0.6-0.9 ohms |
| Ignition Coil Secondary Resistance | 6,000-9,000 ohms |
| Regulated Fuel System Pressure (With Vacuum) | 58.0 + or - 5.0 psi |
| 1 | 30 ft. lbs., step 2: 105 | 30 ft. lbs |
| 1 | 22.0 ft. lbs., Step 2: 33.0 ft. lbs., Step 3: 33.0 ft. lbs., Step 4: 125° without using a torque wrench. Step 5: In reverse order loosen all fasteners., Step 6: 22.0 ft. lbs., Step 7: 33.0 ft. lbs., Step 8: 33.0 ft. lbs., Step 9: 130° without using a torque wrench. | 22 ft. lbs |
Condensed service procedures for routine maintenance. Procedures that require dealer diagnostic equipment are identified and summarized only.
| Tool required | DRBIII scan tool (dealer / locksmith) |
| Why | Transmitter codes are written into the receiver in the passenger door module |
| When needed | After Sentry Key Immobilizer Module (SKIM) replacement |
| Tool required | DRBIII scan tool |
| Also required | The vehicle's four-digit PIN code |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.